Instalaţie de foraj orizontal Nodigmarket24 controlled mole 50m UM-20 nou
Vă interesează anunțul?
1/19
28.000 EUR
≈ 139.300 RON
Marca:
Nodigmarket24
Modelul:
controlled mole 50m UM-20
Tip:
instalaţie de foraj orizontal
Locul de amplasare:
Polonia Zabrze
Data publicării:
mai mult de o lună
Machineryline ID:
RJ18321
Stare
Stare:
nou
Inspecție la distanță
Solicitați o verificare tehnică independentă
Aveți nevoie de livrare?
Calculați prețul livrării
Important
Această ofertă are caracter orientativ. Informaţiile exacte trebuie solicitate vânzătorului.
Recomandări pentru achiziționare
Contactează vânzătorul
"NODIGMARKET24"
În vînzare:
15 anunțuri
5 ani pe Machineryline
5.0
25 comentarii
Telefoanele au fost verificate
The machines are produced with various hydraulic parameters. The example machine in the pictures has a tensile force of 200kN (20t) and allows pulling PE pipes up to 200mm.
The maximum length of the jacking is 60m. It also enables cracking on small asbestos, cast iron and stoneware pipes.
Execution of the controlled squeeze takes place at the execution of a small excavation, rough setting of the machine, arming the warhead with a radio probe and pilot drilling. Then, mount the expanding head depending on the diameter of the installed pipe and pull it into the ground. The whole process is done dry. Drilling polymers are used to retract the pipe over a longer distance. giving a significant slip and reducing friction when pulling.
If you have questions or interest, please contact us via the form or by phone.
Eng. Damian Sobczak
Specialist in the construction of culverts and mechatronics
Maszyny są produkowane z różnymi parametrami hydraulicznymi. Przykładowa maszyna na zdjęciach ma siłę uciągu 200kN
i umożliwia wciąganie rur PE w zakresie średnic 32-160mm.
W komplecie 30m żerdzi, agregat, głowice i uchwyty do rur.
Maksymalna długość wykonania przecisku to 50-60m. Umożliwia również wykonanie krakingu na rurach azbestowych, żeliwnych, kamionkowych oraz PVC polietylenowych.
Wykonanie przecisku sterowanego, odbywa się na wykonaniu niewielkiego wykopu, zgrubnym ustawieniu maszyny, uzbrojeniu głowicy w sondę i wykonanie przewiertu pilotażowego. Następnie zamontowaniu głowicy poszerzającej w zależności od średnicy instalowanej rury oraz wciągnięcie jej w grunt. Cały proces odbywa się na sucho. Do wciąganie rury na dłuższym odcinku stosowane są polimery wiertnicze. dające znaczny poślizg i zmniejszenie tarcia podczas wciągania.
W razie pytań lub zainteresowania proszę kontaktować się poprzez formularz lub telefonicznie.
inż. Damian Sobczak
Specjalista d/s budowy przepustów i mechatroniki